Panasonic PN28080K-ID Operation Manual

Also see for PN28480K-ID: Operation manual Operation manual Installation guide

Contents

Panasonic PN28080K-ID Operation Manual Manual pdf 92 page image

92If you find any problems, please take the following steps to check.◆ LED indicators■ The POWER LED (Power) is not lit.● Is the correct port LED display mode selected by pressing the LED switchbutton?● Is the power cord connected? Please confirm that the power cord issecurely connected to the power port.● Use the switch within the range of operating temperature.■ The Port LED is not lit in Status mode.● Is the cable correctly connected to the target port?● Is an appropriate cable used?● Is a 10BASE-T, 100BASE-TX, or 1000BASE-T terminal connected to the tar-get port?● Auto-negotiation may have failed.→ Set the port of this switch or the terminal to half-duplex mode.■ The port LED (Right) is lit solid orange.● A loop is occurring. When you recover from the loop, the solid orange LEDis turned off.■ LOOP HISTORY LED is flashing green.● There is a port with a loop or a port on which a loop had recovered within3 days.◆ Communications fail.■ Communications with all ports are down or slow.● Are the communication speed and mode settings correct?→ When a communication mode signal cannot be properly obtained, theswitch operates in half-duplex mode.Switch the communication mode of the connection target to half-duplexmode.Do not fix the communication mode of the connected device to full-duplex mode.● Are the ports linking up?→ If the MNO series power saving mode is set to "Full", try setting it to"Half" or "Disabled."● Is the bandwidth usage rate of the backbone network to which this switchis connected excessively high?→ Try separating this switch from the backbone network.● Is the port LED (Right) lit solid orange?→ If the port LED (Right) is lit solid orange, the port is being blocked by theLoop detection and blocking function. After the port is recovered fromthe loop, wait for more than the recovery time until a port starts to beautomatically recovered, or release the blocked port on the configura-tion screen.Appendix C.Troubleshooting

/ 94

Related manuals for Panasonic PN28480K-ID