Panasonic PN28080K-ID Operation Manual

Also see for PN28480K-ID: Operation manual Operation manual Installation guide

Contents

Panasonic PN28080K-ID Operation Manual Manual pdf 11 page image

112. Web Browser-based ControlThe Web browser-based control function (hereinafter called the Web control func-tion) allows you to easily perform administration tasks, such as configuration andmonitoring, from a web browser, Microsoft Internet Explorer.The Web control function allows you to configure and monitor this switch over thenetwork via the user interface of your Web browser. You can also control thisswitch from a remote location as if it is at your fingertips because statuses can bedisplayed.2.1. System RequirementsYou need to configure the network settings before using the Web control functionof this switch.1. Configuring the System IP AddressUsing the console, configure the IP address of this switch.Select "Basic Switch Configuration..." > "System IP Configuration" > "Set IPAddress" to configure the IP address. Then, select "Set Subnet Mask" to config-ure the subnet mask. If required, select "Set Default Gateway" to configure thedefault gateway address.2. Enabling the Web Control FunctionEnable the Web control function of this switch.From the main menu, select "Basic Switch Configuration..." > "System SecurityConfiguration" > "Web Server Status" and the command prompt changes to"Enable or Disable web server (E/D) ." Enter "e" to enable the Web control func-tion. "Disable" is the factory default setting.The terminal to be accessed should have Microsoft Internet Explorer 11.0 installed.Also, the terminal needs to directly connect to a network or this switch.Note: The active window may not be correctly displayed if you use a proxy. Directaccess without a proxy is recommended.