Panasonic PN28080K-ID Operation Manual

Also see for PN28480K-ID: Operation manual Operation manual Installation guide

Contents

Panasonic PN28080K-ID Operation Manual Manual pdf 19 page image

193.1.2. IP ConfigSelect "Basic Config" and "IP Config" to open the screen shown in Figure 3-2. Onthis screen, you can configure the IP address of this switch.Figure 3-2 IP ConfigScreen DescriptionMAC Address Displays the MAC address of this switch.This item is uniquely assigned to each device and cannot be changed.IP Address Displays the current IP address."0.0.0.0" is the factory default setting.SubnetMaskDisplays the current subnet mask."0.0.0.0" is the factory default setting.DefaultGatewayDisplays the IP address of the router, set as a current default gateway."0.0.0.0" is the factory default setting.IPv6 Status Displays whether access via IPv6 is enabled or disabled.Enable Enables access via IPv6.Disable Disables access via IPv6. (Factory default setting)IPv6 Link LocalAddressDisplays the current IPv6 link local address. "::" is the factory default setting.IPv6 Address/Prefix LengthDisplays the current IPv6 address and prefix length. "::/128" is the factory defaultsetting.IPv6 DefaultGatewayDisplays the IPv6 address of the router, set as a current default gateway. "::" is thefactory default setting.