573.2.8. 802.1X Access ControlSelect "Advanced Config" and "802.1X Access Control" to open the screen shownin Figure 3-33. On this screen, you can configure port-based access control usingIEEE802.1X.Figure 3-33 802.1X Port Based Access Control ConfigurationScreen DescriptionNAS ID Displays the authentication ID (NAS Identifier) .Port Number Displays the target port number.Initialize Initializes the authentication status.Re-auth Initialize Initializes the re-authentication status.Port Status Displays the authentication status. This status reflects the Port Control settinglisted below.Unauthorized The authentication is denied.Authorized The authentication is approved.Port Control Displays the operation for authentication request.Auto Enables the authentication function and ignores all theauthentication requests from a client.Force Unauthorized Disables the authentication function and blocks all com-munications.Force Authorized Disables the authentication function and permits allcommunications. (Factory default setting)TransmissionPeriodThis is the time interval until a retransmission request is sent to the client. Thefactory default setting is 30 seconds.Supplicant Time-outDisplays the timeout time for the client. The factory default setting is 30 sec-onds.
