723.2.18. DMI (DDM) ConfigSelect "Advanced Config" and "DMI (DDM) Config" to open the screen shown inFigure 3-44. On this screen, you can configure the DMI (Digital Diagnostic Monitor-ing Interface) settings.Figure 3-44 DMI (DDM) ConfigScreen DescriptionLimit Trap Displays the status of the Limit Trap function.Enable Enables Limit Trap.Disable Disables Limit Trap.Target SFP PortNumberDisplays the SFP port number to be displayed and configured.Vendor Name Displays the vendor name.Port Product Num-berDisplays the product number.Port Serial Number Displays the serial number.Transceiver Type Displays the Transceiver Type.RX Power(dBm) Displays the current, maximum, and minimum values of RX Power(dBm). Themaximum and minimum values can be configured.TX Power(dBm) Displays the current, maximum, and minimum values of TX Power(dBm). Themaximum and minimum values can be configured.Temp(deg.C) Displays the current, maximum, and minimum values of Temp(deg.C). Themaximum and minimum values can be configured.Voltage(V) Displays the current, maximum, and minimum values of Voltage(V). The maxi-mum and minimum values can be configured.Bias Current(mA) Displays the current, maximum, and minimum values of Bias Current(mA). Themaximum and minimum values can be configured.
