2.16 [10] CO & Incoming CallPC Programming Manual 7612.16.3 [10-3] DDI / DID TableIncoming trunk calls with DDI/DID numbers can be distributed to specific destinations. Each DDI/DIDnumber has a destination programmed for each time mode (day/lunch/break/night).When CLI distribution is enabled for a DDI/DID number, incoming trunk calls with that DDI/DIDnumber will be distributed to the CLI destinations (instead of the DDI/DID destinations) if the caller'sidentification number is found in the System Speed Dialling Table, which is used as the Caller IDTable. CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on aDDI/DID number basis.A maximum of 1000 DDI/DID numbers can be programmed with other related parameters. 100numbers are displayed at a time. To display other sets of numbers, click the applicable tab.To assign DDI/DID destination numbers, enter directly or click Destination Setting (see 2.1.6Extension Number Setting). It is possible to programme DDI/DID numbers and DDI/DIDdestinations in each time mode (day/lunch/break/night) for a set of locations in series at once byclicking Automatic Registration, or to programme DDI/DID names for a set of locations in series atonce by clicking Name Generate.DDI / DID NumberSpecifies the DDI/DID number.Value RangeMax. 32 digits (consisting of 0–9, *, and #)Maintenance Console Location2.16.3 [10-3] DDI / DID TableProgramming Manual References2.16.4 [10-3] DDI/DID Table—Automatic RegistrationFeature Guide References1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)DDI / DID NameSpecifies the name for the DDI/DID number which is shown on the extension's display when receivinga call with the DDI/DID number. The name of the DDI/DID number can be printed out on SMDR.Value RangeMax. 20 charactersMaintenance Console Location2.16.3 [10-3] DDI / DID TableProgramming Manual References2.16.5 [10-3] DDI/DID Table—Name Generate2.17.1 [11-1] Main—SMDR Options—SMDR Options—DDI/DID Number & Name
