2.10 [4] Extension636 PC Programming Manual2.10.11 [4-2-1] Portable Station—Extension Settings—CLIPGenerateCLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together.Pre-assigned CLIP numbers for those locations will be overwritten.If a number generated here is longer than 16 digits, the additional digits will be discarded.Location Entry—Beginning Entry Location (Ext. Number)Specifies the extension number of the first location to be programmed.Value RangePS extension numberMaintenance Console Location2.10.11 [4-2-1] Portable Station—Extension Settings—CLIP GenerateProgramming Manual References2.10.10 [4-2-1] Portable Station—Extension SettingsFeature Guide References1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)Location Entry—Number to GenerateSpecifies the number of locations to be programmed.A CLIP number will only be assigned to registered PS extensions, even if the number entered here islarger than the total number of PS extensions.Value Range1–total number of connected wired extensionsMaintenance Console Location2.10.11 [4-2-1] Portable Station—Extension Settings—CLIP GenerateProgramming Manual References2.10.10 [4-2-1] Portable Station—Extension SettingsFeature Guide References1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)Parameter—Deleting DigitsSpecifies the number of digits to be deleted from the start of an extension number when using it aspart of the CLIP number.Value Range0–4
