Panasonic KX-TDA100 Programming Manual

Also see for HYBRID IP-PBX KX-TDA100: User guide User guide Technical information Technical information Features guide

Contents

Panasonic KX-TDA100 Programming Manual Manual pdf 455 page image

2.8 [2] SystemPC Programming Manual 4552.8.18 [2-10] Extension CID SettingsVarious settings for extension Caller ID can be programmed.Extension Caller ID Resource-1, 2 (KX-TDA30 only)Specifies a group of 4 SLT ports that can transfer Caller ID information to connected SLTs.When the port to which an extension is connected has this feature activated, there will be a shortdelay before the extension rings for incoming calls.Value RangeDisable: No portSlot 01:DHLC4: Initially installed 4 Super Hybrid portsSlot nn:SLC4: Ports 1 to 4 of the SLC4 card (nn=slot number)Slot nn:SLC8 1-4: Ports 1 to 4 of the SLC8 card (nn=slot number)Slot nn:SLC8 5-8: Ports 5 to 8 of the SLC8 card (nn=slot number)Maintenance Console Location2.8.18 [2-10] Extension CID SettingsProgramming Manual References2.10.1 [4-1-1] Wired Extension—Extension Settings—Option 7—Extension Caller ID SendingFeature Guide References1.18.1 Caller IDExtension Caller ID Modulation TypeSpecifies the modulation frequency to be used when sending Caller ID information to an SLT.Value RangeV.23(ETSI), Bell202(Bellcore)Maintenance Console Location2.8.18 [2-10] Extension CID SettingsProgramming Manual ReferencesNoneFeature Guide References1.18.1 Caller IDChannel Seizure Signal bitsSpecifies the number of seizure bits to send when sending Caller ID information to an SLT.Value Range10 × n (n=3–40) bits