2.8 [2] SystemPC Programming Manual 4632.8.21 [2-12] IP Extension Settings (KX-TDA100/KX-TDA200/KX-TDA600 only) (not available for MPR Software File Version3.1000 or later)IP-PT network data transmission settings can be programmed. To activate any changes made tosettings on this screen, it is necessary to set all installed IP-EXT cards to OUS, then back to INS.For MPR Software File Version 3.1000 or later, refer to 2.7.37 [1-1] Slot—IP-Extension CardProperty—Common Settings (KX-TDA100/KX-TDA200/KX-TDA600 only) (MPR Software FileVersion 3.1000 or later).Gateway AddressSpecifies the default gateway address of the network for IP-PTs.Value Range0.0.0.0–223.255.255.255Maintenance Console Location2.8.21 [2-12] IP Extension Settings (KX-TDA100/KX-TDA200/KX-TDA600 only) (not available forMPR Software File Version 3.1000 or later)Programming Manual ReferencesNoneFeature Guide References1.31.1 IP Proprietary Telephone (IP-PT)Voice (RTP) UDP Port No. (Server)Specifies the UDP port used by the IP-EXT card to transmit and receive RTP (Realtime TransferProtocol) data. This must be changed if another network application is using the same port.For voice communications, an IP-EXT card uses 64 contiguous UDP ports, starting from the portnumber specified here.Value Range1024–65472Maintenance Console Location2.8.21 [2-12] IP Extension Settings (KX-TDA100/KX-TDA200/KX-TDA600 only) (not available forMPR Software File Version 3.1000 or later)Programming Manual ReferencesNoneFeature Guide References1.31.1 IP Proprietary Telephone (IP-PT)
