Panasonic KX-TDA100 Programming Manual

Also see for HYBRID IP-PBX KX-TDA100: User guide User guide Technical information Technical information Features guide

Contents

Panasonic KX-TDA100 Programming Manual Manual pdf 709 page image

2.12 [6] FeaturePC Programming Manual 7092.2.5 Operator FeaturesARS ModeSpecifies the ARS mode used when making a trunk call.Value RangeOff: ARS is disabled.On for Local Access Operation: ARS operates when an extension user makes a call using any IdleLine Access method.On for Any CO Access Operation: ARS operates when an extension user makes a call using anyTrunk Access method.Same as System Setting: The setting specified in ARS Mode in 2.14.1 [8-1] System Settings isapplied.Maintenance Console Location2.12.6 [6-6] TenantProgramming Manual References2.14.1 [8-1] System SettingsFeature Guide References1.10.1 Automatic Route Selection (ARS)2.2.3 Tenant ServiceSystem Speed DialSpecifies which system speed dialling table is used by the tenant. This setting is only available whenan MEC (KX-TDA30/KX-TDA100/KX-TDA200) or EMEC (KX-TDA600) card is installed.Value RangeFor KX-TDA30:Basic Memory: PBX basic system speed dialling numbers are used.Expanded Memory: Expansion system speed dialling numbers are used.For KX-TDA100/KX-TDA200/KX-TDA600:Same as System Setting: PBX common system speed dialling numbers are used.Tenant Exclusive: Individual tenant system speed dialling numbers are used.Maintenance Console Location2.12.6 [6-6] TenantProgramming Manual References2.12.1 [6-1] System Speed DialFeature Guide References1.6.1.5 Speed Dialling—Personal/System2.2.3 Tenant Service