Adjusting the Angle of theCameraYou can manually change the viewing angle of thecamera, or select from positions programmed in thecamera.Changing the center point1. Touch the video display area to center the cameraat that point.Panning and tilting the camera manually1. Press to enable the panning and tilting controls.Four arrows will appear along the edges of the videodisplay.2. Press the arrows to pan and tilt the camera.Performing a pan/tilt scanA pan/tilt scan is when the camera pans (horizontal) ortilts (vertical) as far as possible in one direction, andthen pans/tilts as far as possible in the other direction.Finally, the camera returns to its original position.Use the following buttons to perform a pan/tilt scan:• : Perform a pan scan• : Perform a tilt scanSelecting a programmed position1. Press the Position drop-down list, and then selectthe position you want to view.Note• Positions are programmed via the camera’ssettings, and cannot be programmed from theKX-NT400.• If a position name contains non-ASCIIcharacters, the position name will appeargarbled.• The text "Preset" is always displayed in thePosition drop-down list, even after you select aprogrammed position.Opening DoorsIf you are on a call with a doorphone and are viewingthe feed from a camera integrated with the doorphone,you can open the door from the KX-NT400.1. On the Camera screen, press .Usage tips• Press to mute your voice during a doorphonecall. For details about muting, see "Mute(Page 72)".Full-Screen ModeYou can expand the video area to fill the entire screen.1. On the Camera screen, press .In full-screen mode, you can do the following:• Press (ENTER) on the Navigator key tomove the camera to its home position.• Touch the screen or press (CANCEL) toreturn to the Camera screen.82 Operating Instructions Document Version 2010-01Advanced Feature Operation
