43. Basic operations3-5-2. Selecting the DSK material Selecting the DSK fill signal and DSK source signalPress the [DSK] button in the AUX bus selection area to switch the selection of the DSK fill signal (indicatorlights in amber) and DSK source signal (indicator lights in green).While the indicator of the [DSK] button is lit in amber,press one of the AUX bus crosspoint buttons 1 to 10to select the DSK fill signal.The indicator of the selected AUX bus crosspointbutton lights in amber. (It lights in red if the selectedsignal is being output from the PGM connector.) Lighting in amberKEY DSK PinP AUX CLN PVW PGMAUX SOURCEAUX BUS DELEGATIONAUXAMB:FILL / GRN:SOURCEWhile the indicator of the [DSK] button is lit in green,press one of the AUX bus crosspoint buttons 1 to 10to select the DSK source signal.The indicator of the selected AUX bus crosspointbutton lights in green. (It lights in red if the selectedsignal is being output from the PGM connector.)Since the luminance key is operated as a self key,the key fill signals are used as the key sourcesignals. When the luminance key has been selectedas the downstream key type, the key signals willremain unchanged even when the key sourcesignals are switched. Lighting in greenKEY DSK PinP AUX CLN PVW PGMAUX SOURCEAUX BUS DELEGATIONAUXAMB:FILL / GRN:SOURCE Setting the fill matte colour1 On the KEY menu, turn [F1] to display the FillMatt submenu.2 Turn [F], [F3] and [F4] to adjust the Hue, Sat and Lumof the fill matte.To call the preset colourTurn [F] to select the preset colour using the Load item,and press the [F] switch.The Hue, Sat and Lum values are changed to the presetcolour values. To save the values that were set before calling thepreset colour, refer to “3-10. Preset memory”.FillMatt Hue Sat Lum Load↓3/7 0.0 0.0 100.0 White0.0|359.90.0|100.00.0|108.0YellowCyanGreenMagentaRedBlueBlack
