|
1016. External interfacesThis unit comes with RS-4, GPI and tally connectors to serve as external interfaces.6-1. RS-422 connectorThis enables the unit to be controlled by an external device.Use it with the settings below. (D-sub 9-pin, female, inch screw)Baud rate: 38400 bpsParity: ODDStop bit: 1 bit123459 8 7 6Pin assignmentPin No. Signal name Description of signal1 FRAME GROUND Frame ground TXD – Send data (–)3 RXD + Receive data (+)4 GROUND Ground NC Not used6 GROUND Ground7 TXD + Send data (+)8 RXD – Receive data (–)9 FRAME GROUND Frame groundThe following lists the functions which can be controlled by editing controller AG-A80.(Compliant with the GVG protocol)• Crosspoint switch• Wipe pattern selection (BKGD)• Transition mode (MIX/WIPE) selection• Auto transition time setting• Auto transition executionGVG protocol AV-HS400AE GVG protocol AV-HS400AE GVG protocol AV-HS400AE GVG protocol AV-HS400AEA B A B A B A B0 1 WIPE #1 1 13 SQ #1 4 SL #1 36 37 3D #11 WIPE # 13 14 SQ # 6 SL # 37 38 3D # 3 WIPE #3 14 1 SQ #3 6 7 SL #3 38 39 3D #33 4 WIPE #4 1 16 SQ #4 7 8 SL #4 39 40 3D #44 WIPE # 16 17 SQ # 8 9 SL # 40 41 3D # 6 WIPE #6 17 18 SQ #6 9 30 SL #6 41 4 3D #66 7 WIPE #7 18 19 SQ #7 30 31 SL #7 4 43 3D #77 8 WIPE #8 19 0 SQ #8 31 3 SL #8 43 44 3D #88 9 WIPE #9 0 1 SQ #9 3 33 SL #9 44 4 3D #99 10 WIPE #10 1 SQ #10 33 34 — 4 46 3D #1010 11 WIPE #11 3 — 34 3 — 46 47 3D #1111 1 WIPE #1 3 4 SQ #1 3 36 — 47 48 3D #1: Set “No. 6” when control is to be exercised from the AG-A80.On the System sub menu of the SYSTEM menu, set On or Off for control from the external device (editor)connected to the RS-4 connector.For details on the settings, see -6-.
PreviousNext Related manuals for Panasonic AV-HS400AE This manual is suitable for: |
