43Setup menus (continued)OPERATION (continued)*1 Even if the RESET button is pressed while pressing theSEARCH button, the value may not return to the factorysetting.*2 Displayed menus may vary depending on the settings inmenu No. 25 SYSTEM FREQ. For details, refer to“Menus which are displayed” (page 32).INTERFACE“_____” indicates the factory setting.No./Item Description of setting181*1TYPE-ANEARFor setting (in increments of 0.1 V) the voltage level atwhich the counter flashes as warning for TYPE-Abattery (selected as the menu item No.180 BATTERYSEL item).Use when adjusting the settings for multiple batteriesor new type batteries.0000 10.6: :0023 12.9: :0044 15.0When this item has been set to a voltage level closeto 15.0 V, the counter display may flash even when anAC power source is being used.182*1TYPE-A ENDFor setting (in increments of 0.1 V) the voltage level atwhich the TYPE-A battery (selected as the menu itemNo.180 BATTERY SEL item) is to be automaticallyturned off.Use when adjusting the settings for multiple batteriesor new type batteries.0000 10.6: :0018 12.4: :0034 14.0183*1TYPE-BNEARFor setting (in increments of 0.1 V) the voltage level atwhich the counter flashes as warning for TYPE-Bbattery (selected as the menu item No.180 BATTERYSEL item).Use when adjusting the settings for multiple batteriesor new type batteries.0000 10.6: :0023 12.9: :0044 15.0When this item has been set to a voltage level closeto 15.0 V, the counter display may flash even when anAC power source is being used.184*1TYPE-B ENDFor setting (in increments of 0.1 V) the voltage level atwhich the TYPE-B battery (selected as the menu itemNo.180 BATTERY SEL item) is to be automaticallyturned off.0000 10.6: :0018 12.4: :0034 14.0190*2V IN SEL INHFor selection of the video input switching mode withthe INPUT SELECT switch.0000 OFF :Video input switching with the INPUT SELECTswitch is enabled.0001 ON :Video input switching with the INPUT SELECTswitch is prohibited.0002 REC :After this unit shifts to recording (except editing),video input switching with the INPUT SELECTswitch is prohibited.No./Item Description of setting191* 2A IN SEL INHSelect the audio input switching mode with the INPUTSELECT switch.0000 OFF :Select the audio input switching mode with theINPUT SELECT switch.0001 ON :Video input switching with the INPUT SELECTswitch is prohibited.0002 REC :After this unit shifts to recording (except editing),video input switching with the INPUT SELECTswitch is prohibited.No./Item Description of setting202ID SELFor setting the ID information to be returned to thecontroller.0000 OTHER :The ID information of the VTR other than DVCPROis set.0001 DVCPRO :The DVCPRO ID information is set.0002 ORIG :Set this only when the unit is connected to aPanasonic controller (such as the AG-A850,optional accessory).Select 1 (DVCPRO) or 2 (ORIG) if “23/24,” “25(HD),”“25(SD),” “50(HD)” or “50(SD)” is selected as themenu item No.25 SYSTEM FREQ setting.
