39Setup menus (continued)BASIC (continued)*1 Displayed menus may vary depending on the settings inmenu No. 25 SYSTEM FREQ. For details, refer to“Menus which are displayed” (page 32).“_____” indicates the factory setting.Formats for playbackDepending on how the menu item No.020 SYS FORMAT,No.022 PB FORMAT and No.023 FORMAL SEL settings arecombined, the formats of the tapes played back by the unitdiffer as shown in the table below.z When the tape is ejected, the format follows the oneselected by menu item No.020 SYS FORMAT setting.z DVCPRO P playback is not possible.No./Item Description of setting030*1HDFREQUENCYFor setting the field frequency.0000 59/23 :The field frequency is set to 59.94/23.98 Hz.0001 60/24 :The field frequency is set to 60/24 Hz.The field frequency which is set here takes effect onlywhen there is no input which supports the OUT REFsetting.If there is an input which supports the setting, thefield frequency is consistent with the field frequencyof input.031*1OUT REFFor selecting the video output reference.0000 AUTO :The REF signal (HD/SD) which is input to the REFconnector is automatically identified and serves asthe reference.If no signal is supplied to the REF connector, theHD serial input signal serves as the reference.If neither the REF input signal nor HD serial inputsignal is supplied, the unit’s internal reference isused.0001 INPUT :The input signal serves as the reference.If this signal is not available, the unit’s internalreference is used.0002 HD REF :The HD REF input signal serves as the reference.If this signal is not available, the unit’s internalreference is used.0003 SD REF :The SD REF input signal serves as the reference.If this signal is not available, the unit’s internalreference is used.0004 E-AUTO :When the editing mode is selected, the state is thesame as when set to “INPUT.”When any mode other than the editing mode isselected, the state is the same as when set to“AUTO.”For details, refer to “Reference signals” (page 16).032*1REC REFSelect the reference to synchronize the image framesfor recording.0000 NORMAL :The video signal which is input is automaticallyidentified and serves as the reference.0001 SLTC :The time code which is input to the HD SDI INconnector isidentified and serves as the reference.When the SLTC is selected, the following settings arenecessary to validate the settings for this item.z Menu No. 25 SYSTEM FREQ: 59/60z Menu No. 020 SYS FORMAT: 720pz INPUT SELECT button on the front panel: HDSDI022.PB FORMAT020.SYS FORMAT023.FORMAT SEL Playback formatMANUAL1080iHD_LP DVCPRO HD-LP (1080i)HD_SP DVCPRO HD (1080i)50M DVCPRO50 (422)25M DVCPRO (411)DV DVDVCAM DVCAM720PHD_LP DVCPRO HD-LP (720p)HD_SP DVCPRO HD (720p)50M DVCPRO50 (422)25M DVCPRO (411)DV DVDVCAM DVCAMAUTOIf AUTO is selected as themenu item No.022 PBFORMAT setting, theformat applying when theformat is not yet detected(when the tape inserted)follows the menu itemNo.023 FORMAL SELsetting.However, if “DV” or“DVCAM” is selected,operation proceeds as if“HD_LP” is selected.DVCPRO HD-LP(1080i/720p),DVCPRO HD (1080i/720p), DVCPRO50(422), DVCPRO (411),DVCPROP (420p), DCor DVCAM format isdetected automatically.
