Troubleshooting 8-17The PXE boot (network boot) fails or the server is not found on the network:T Is the cable connected properly?→ Connect the proper cable to the network port on the rear of the Express server. Inaddition, make sure that the used cable conforms to the network interfacestandard.T Is BIOS configuration correct?→ The internal LAN controller may be disabled with the CMOS Setup utility of theserver. Check the setting with the BIOS setup utility.T Have the protocol and service already configured?→ Install the distinctive network driver for the server. Make sure that the protocol,such as TCP/IP, and services are properly specified.T Is the transfer speed correct?→ Open the network property dialog box in control panel to specify the link speedand duplex value the same as the value specified for HUB.
