5-30 Installing the Operating System with Express SetupNOTES: If you click [Cancel] in [Basic Information] screen, the screen willgo back to select the Setup File. [Cancel] exists only in [BasicInformation] screen. If you click [OK] in [Role of Computer] screen, the setupautomatically selects default value for the later specification tocontinue the installation.When all the specification has completed, the system reboots automatically.9. Copy the modules for the optional mass storage driver.If you want to install the optional mass storage driver, insert the floppy disk attached tomass storage driver into the floppy disk drive and follow the message to operate theinstallation.10. Follow the message and take NEC EXPRESSBUILDER CD-ROM and ConfigurationDiskette out of the CD-ROM drive and the floppy disk drive, and insert Windows 2000CD-ROM into the CD-ROM drive.[Software License Agreement] screen appears.11. Read the contents carefully and click [I agree.] or press F8 if you do agree. If you do notagree, click [I disagree] or press F3.IMPORTANT: If you do not agree to this agreement, the setup terminates andWindows 2000 will not be installed. If "NetWare Gateway (and Client) Service" is specified to install,the window to specify the details of "NetWare Gateway (andClient) Service" pops up on the first logon. Specify theappropriate value.12. If you selected [Apply] on [Apply Service Pack] at Basic Information, follow theprocedure below.1) Follow the message to take Windows 2000 CD-ROM out of the CD-ROM drive.2) Follow the message to insert Windows 2000 Service Pack 4 or later into the CD-ROM drive.Windows 2000 and the specified application will be installed automatically and logon tothe system. Install and configure the device drivers.Now the Setup using Express Setup has completed.IMPORTANT: Without applying Service Pack and applying ServicePack 1, 2, or 3 to this system are not supported.If you install Windows 2000 CD-ROM which contains ServicePack 4to your system, you do not have to apply Service Pack 4 again.
