Lenovo RackSwitch G8264 Application Manual

Also see for RackSwitch G8264: Installation guide Product guide Product guide Command reference Installation guide

Contents

74 G8264 Application Guide for ENOS 8.4Setup Part 3: VLANsIf you chose to skip VLANs configuration back in Part 2, skip to “Setup Part 4: IPConfiguration” on page 75.1. Select the VLAN to configure, or skip VLAN configuration at the prompt:If you wish to change settings for individual VLANs, enter the number of theVLAN you wish to configure. To skip VLAN configuration, press withouttyping a VLAN number and go to “Setup Part 4: IP Configuration” on page 75.2. Enter the new VLAN name at the prompt:Entering a new VLAN name is optional. To use the pending new VLAN name,press .3. Enter the VLAN port numbers:Enter each port, by port number or port alias, and confirm placement of the portinto this VLAN. When you are finished adding ports to this VLAN, press without specifying any port.4. Configure Spanning Tree Group membership for the VLAN:5. The system prompts you to configure the next VLAN:Repeat the steps in this section until all VLANs have been configured. When allVLANs have been configured, press without specifying any VLAN.VLAN Config:Enter VLAN number from 2 to 4094, NULL at end:Current VLAN name: VLAN 2Enter new VLAN name:Define Ports in VLAN:Current VLAN 2: emptyEnter ports one per line, NULL at end:Spanning Tree Group membership:Enter new Spanning Tree Group index [1 255]:VLAN Config:Enter VLAN number from 2 to 4094, NULL at end: