© Copyright Lenovo 2016 Chapter 1: Switch Administration 555. Press Q to reboot the switch:6. After the reload is complete, log into the switch by using the default user adminwith the default password ʹadminʹ.7. Enter configuration mode (config). Copy the active configuration to the runningconfiguration by using the copy active config running configadmin pw bypass command.8. Use the show run command to confirm the configuration is recovered. Set the newadmin and enable passwords. Save the running configuration to startupconfiguration.9. Make sure the boot configuration‐block is active by using the show bootconfiguration block command. If it’s not active, change the bootconfiguration‐block by executing the following command:Boot Management MenuI Change booting imageC Change configuration blockR Boot in recovery mode (xmodem download of images to recoverswitch)Q RebootE ExitPlease choose your menu option: qResetting the board.Switch>enaEnable privilege granted.Switch#configure terminalEnter configuration commands, one per line. End with Ctrl/Z.Switch(config)#copy active config running config admin pw bypassLoading to current configuration.Switch(config)#passwordChanging admin password; validation required:Enter current local admin password:Enter new admin password (max 64 characters):Re enter new admin password:New admin password accepted.Password changed and applied, but not saved.Notifying administrator to save changes.Switch(config)#enable password ?WORD The UNENCRYPTED (cleartext) 'enable' passwordSwitch(config)#enable password admin1Switch(config)#copy running config startup configConfirm saving to FLASH (y/n) ? yCopy running configuration to startup configurationSwitch is currently set to use factory default config block on next boot.Do you want to change that to the active config block (y/n) ? yNext boot will use active config block.Switch(config)#boot configuration block active
