© Copyright Lenovo 2016 Chapter 1: Switch Administration 49Basic System Mode Configuration ExampleThis example shows the parameters available for configuration in Basic Systemmode:Note: You can either accept the default values or enter new parameters.Transparent Mode Configuration ExampleThis example shows the parameters available for configuration in Transparentmode:Notes: If your selection for a port group contains ports of different mode or speed, theselection is not valid and you are guided to either select other ports or changethe speed of the ports. You can either accept the static defaults or enter a different port list for uplinkand/or server ports.RS G8264# easyconnectConfigure Basic system (yes/no)? yPlease enter "none" for no hostname.Enter hostname(Default: None)? hostPlease enter "dhcp" for dhcp IP.Select management IP address (Current: 10.241.13.32)?Enter management netmask(Current: 255.255.255.128)?Enter management gateway:(Current: 10.241.13.1)?Pending switch port configuration:Hostname: hostManagement interface:IP: 10.241.13.32Netmask: 255.255.255.128Gateway: 10.241.13.1Confirm erasing current config to re configure Easy Connect (yes/no)?RS G8264# #easyconnectConfigure Transparent mode (yes/no)? ySelect Uplink Ports (Static Defaults: 17 24)?The following Uplink ports will be enabled:Uplink ports(1G/10G): 17 24Select Server Ports (Static Defaults: 25 64)?The following Server ports will be enabled:Server ports(1G/10G): 25 64Pending switch configuration:Uplink Ports: 17 24Server Ports: 25 64Disabled Ports: 1,5,9,13Confirm erasing current config to re configure Easy Connect (yes/no)?
