40Example 6-5: Operation Mode Control on DriversRequirements: Defines the input port DIN3 as the operation mode control on drivers, and the operationmode is ―-4‖ (pulse control mode) when DIN3 fails, and is ―-3‖ (instantaneous speed mode) when DIN3 isvalid. Table 6-13 describes the setup method.Table 6-13 Settings on operation mode control on driversNumeric Display Variable Name Parameter Settingsd3.03 Din3_Function Set to 000.4d3.16 Din_Mode0 Set to 0.004 (-4)d3.17 Din_Mode1 Set to 0.003 (-3)d3.00 Store_Loop_Data Set to 1Note: If the driver is required to operate in some mode with power on, one of the digital input must be set asfunction ―Operation Mode Control‖. Then you can set the operation modes that require in the parametersd3.16 or d3.37 in Group F003.6.1.5 Wirings of Digital Input Port1. NPN wiring diagram (to the controller that supports low level output)Fig. 6-2 NPN wiring diagram (to the controller that supports low level output)2. PNP wiring diagram (to the controller that supports high level output)
