68 MRP-2002 Series Instruction Manual — P/N 53049:E5 7/28/2016Programming Master Programming LevelTime-DateThe control panel time and date can be changed by pressing 1 while viewing the System SetupScreen #2. The following screen will be displayed: TimeTo change the time, press 1 while viewing the Time-Date Screen. The following screen will bedisplayed:A flashing cursor is located toward the top left of the display. Below the cursor is the current time.To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor willmove one position to the right each time a digit is entered. After the last minutes digit is entered, thecursor will again move one position to the right. At this point enter 1 for AM or 2 for PM. Thedisplay will then return to the Time-Date Screen which will show the new time entry. If an error ismade while entering a digit, press the CLR key to delete the entire entry and begin again. DateTo change the date, press 2 while viewing the Time-Date Screen. The following screen will bedisplayed:A flashing cursor is located toward the top left of the display. Below the cursor is the current date.To change the date, enter the two-digit month followed by the two-digit day and then the two-digityear (14 for 2014, 15 for 2015, etc.). The cursor will move one position to the right each time adigit is entered. After the last year digit is entered, the display will return to the Time-Date Screenwhich will show the new date entry. If an error is made while entering a digit, press the CLR key todelete the entire entry and beginning again. Clock FormatThe clock can be configured to display 12 hour (AM & PM) or 24 hour (military) time. Pressing 3while viewing the Time-Date screen will cause the display to toggle between 12HR and 24HR.Select 12HR for 12 hour display or 24HR for 24 hour display.SYSTEM SETUP1=TIME-DATE2=TROUBLE REMIND3=CHARGR DISABLESystem Setup Screen #2 TIME AND DATE1=TIME 10:00A2=DATE 092220143=CLOCK FORMAT 12HRTime-Date Screen #1TIME AND DATE1=DAYLIGHT SAVINGSTime-Date Screen #2ENTER TIME AS 12HRS:1=AM 2=PMTime ScreenENTER DATE✱✱-✱✱-✱✱✱✱MONTH DAY YEAR09-22-2014Date ScreenNOTE: If the clock is changed to 24 hour (military) format, the date will change to the Europeanstandard of Day-Month-Year (for display purposes only).
