MRP-2002 Series Instruction Manual — P/N 53049:E5 7/28/2016 43ANN-BUS Devices Installation Setting Printer OptionsRefer to the documentation supplied with the PRN-7 printer for instructions on using the printermenu controls. Set the printer options (under the menu area) as shown in the following table:PRN-6F Printer InstallationWhen connected to the FACP via the ANN-S/PG module, the PRN-6F prints the status changeswithin the control panel and time-stamps the printout with the time of day and date that the eventoccurred. It provides 80 columns of data on standard 9” x 11” tractor-feed paper. This section con-tains information on connecting a printer to the control panel and setting the printer options. Connecting PRN-6F PrinterRemote printers require a primary AC power source. If required for the fire alarm system configu-ration (for example, a Proprietary Fire Alarm System), a remote printer requires a secondary powersource (battery backup). Since a secondary power source is not provided as a standard feature, aseparate UL-listed Uninterruptible Power Supply (UPS) should be used. The building emergencypower supply may be used, as long as it meets the power continuity requirements of NFPA 72.Refer to NFPA 72 for further details.Connect the remote printer to the FACP via the ANN-S/PG module using a standard DB-25 cable.One end of the cable will plug into the DB-25 connector on the PRN-6F printer and the other endplugs into the parallel connector on the ANN-S/PG module. Note that the 9-pin DB-9 port on theANN-S/PG is used to connect a serial printer. The 25-pin port is used for a Centronics parallelprinter cable. Connect either a serial or parallel printer, but not both at the same time.Option Setting Option SettingFont HS Draft CPI 10CPILPI 6 LPI Skip 0.5ESC Character ESC Emulate LQ-2550Bidirectional Copy ON I/OCG-TAB Graphic Buffer 64KCountry E-US ASCII SerialAuto CR OFF Baud 9600 or 2400Color Option Not Installed Format 7 Bit, Even, 1 StopFormien Protocol XON/XOFFLines 6LPI=60 Character Set StandardStandard Exec 10.5 SI.Zero OnBarcode Off Auto LF OnBarcode UnsecuredTable 2.2 PRN-7 Setup Options
