Honeywell GX-Series Installation And Setup Manual

Contents

Honeywell GX-Series Installation And Setup Manual Manual pdf 60 page image

GX-Series Control Panel Installation and Setup Guide6-14Pressing the # key while viewing the log can reveal additional information about certain event types:• User events reveal the keypad, user type and user group involved in the event;• Alarm events reveal the zone descriptor, if programmed.• REM CALL event displays the Remote Station ID for the Remote Servicing Software which hasmade the connection with the panel.GX-097-V0 LEVEL OF USER CODEKEYPAD ADDRESSAB LINEK = KEYPADNOTES: 1. Where two identical events occur within 1 second, only one is logged.2. Only the first occurrences of high resistance and low resistance events on each day are logged.Subsequent activations are ignored until midnight of the same day. This is to prevent the log frombeing filled with high and low resistance activations from a faulty zone.The event log can be printed while accessing the Display Log option. Pressing the * key while displaying anevent starts the printout from the displayed event and prints forward to the most recent event. The esc keyaborts the print out.NOTE: A serial printer must be connected to the GX-Series panel via a printer interface module, the RS232interface module, or the RS232 serial port.Option 23 – SystemThis option provides a quick overview of the system configuration; two lines of information are displayed at atime - the A> and keys are used to scroll through the entire list:• Groups use the A> and keys to scroll through groups A1–8, B1–8, C1–8 and D1–8• Group status U = Unset (disarm), S = Set (arm), P = Part set (Part arm) and L = Locked-out foreach of the groups displayed;NOTE: Enabling the Show Status option (refer to option 58 = KEYPADS) allows the group set (armed) status tobe displayed from the normal banner [when the system is set (armed) or unset (disarmed)] by pressingthe * and # keys simultaneously.• Type GX-48 or GX-520• Version version of software in GX-Series panel;• RIOs installed includes the on-board RIOs;• Codes used includes the manager, engineer and remote codes;• Keypads installed 1-8 (GX-48), 1–32 (GX-520)• Comms modules 1-7 (Telecom, RS232, ISDN, Ethernet, Int Telecom, Int RS232);• Printer 0–1 (Printer Interface Module);• DCM Modules gives the number of Door Control Modules on the system;• MUX Modules gives the number of MUX Modules on the system• Panel location up to 16 characters of text entered in System Text parameter (option 51.15.2).Option 24 – Print [Quick Menu Option 5]NOTE: A serial printer must be connected to the GX-Series panel via an on-board RS232 serial port.This option has two sub-menus:1 = Printer Module2 = INT RS232 1Each of these two sub-menus allows one of the four listed options below to be printed. Only informationcorresponding to the groups assigned to the user is printed.