Honeywell GX-Series Installation And Setup Manual

Contents

Honeywell GX-Series Installation And Setup Manual Manual pdf 24 page image

GX-Series Control Panel Installation and Setup Guide2-16Output Address Default function Current (mA)0001 Fire 1000002 Panic 1000003 Intruder 1000004 Set (Arm) 1000005 Omit (Bypass) 1000006 Confirm 100Table 2-9. Trigger Output functionsThe function of the trigger outputs can be programmed in menu option 53 = Program Outputs.NOTE: Not evaluated by UL.SupplyA 100 mA, 12V output is also provided.Not UsedNot UsedGND+12VTrig 1Trig 2Trig 3Trig 4Trig 5Trig 6Not UsedNot UsedGX-019-V0Figure 2-19 Trigger HeaderSPI HeaderThe SPI (Serial Peripheral Interface) key is an engineering peripheral used for copy/overwritingprogramming data and carrying out software upgrades.Fitting the SPI KeyThe SPI key is inserted directly on to the GX-Series control panel.CAUTION: Always power down the panel BEFORE removing or connecting the SPI key. Failure to do so mayresult in damage to the SPI key. Never “hot-plug” the SPI key.The SPI Key has a 10-way connector. These locate on to the 10 pins of the SPI Program Header (see Figuresbelow).NOTE: The SPI Key should only be inserted in the direction shown in Figure 2-19.HINGEDCAPGX-020-V010-WAYCONNECTORFigure 2-20. SPI KeyGX-021-V1CONTROL PANEL(PARTIAL VIEW)SPI KEYINSERTEDHERESPI PROGRAMHEADERFigure 2-21. Location of SPI Key on Program Header