Honeywell GX-Series Installation And Setup Manual

Contents

Honeywell GX-Series Installation And Setup Manual Manual pdf 19 page image

GX-Series Control Panel Installation and Setup Guide2-11ZonesThe default setting for the zones on the GX-Series are as follows:Zone 1001 = FinalZone 1002 = ExitAll remaining zones = IntruderZone AddressesEach zone has a four digit address; 1004, 4136. The address is made up of three reference numbers as shownin the following figure:Example: 3057Represents PanelLine No.RepresentsRIO AddressRepresentsZone No. 1-8 onRIOGX-SeriesPANEL1 2 3 4RIOADDRESS 05 ZONE 73 05 7GX-011-V2Figure 2-11. Zone AddressesFor example, zone 3057 is the detector connected to line 3, RIO 05, zone 7.Zone Addressing with On-board RIO Switch (Line 0 Switch)The RIO switch (SW3, dipswitch 8) controls the ordering of the on-board RIO’s. This dipswitch must be setbefore powering up the panel. Setting the switch to ON sets the on-board RIO1 to operate on line 0 andallows a RIO addressed as 1 to be connected to line 1, giving a total of 15 RIO’s on a GX-520. The RIO switchonly needs to be activated if the maximum number of RIO’s will be used.NOTE: The RIO switch is not functional on other panel variants. It defaults to the Switch off configuration.Switch off (default)When the switch is set to this mode, the on-board RIO’s configure to the following addresses:On-board RIO0 Zone address range: 1001-1008 Outputs: 1001-1004On-board RIO1 Zone address range: 1011-1018 Outputs: 1011-1014Switch onWhen the switch is set to this mode, the on-board RIO’s configure to the following addresses:On-board RIO0 Zone address range: 1001-1008 Outputs: 1011-1014On-board RIO1 Zone address range: 0011-0018 Outputs: 0011-0014Panel On-Board RIO Address RangeTotal on-boardZonesMax No. ofExternalRIO's(Line 1)ValidExternal RIOAddresses(Line 1)Total ZoneAddresses(Switch ON)GX-48 1001 - 1008, 1011 - 1018 (switch off) 16 4 2-5 481001 - 1008, 1011 - 1018 (switch off) 16 15 2 - 9, A - F 520GX-520 1001 - 1008, 0011 - 0018 (switch on) 16 14 1 – 9, A - F 520Table 2-5. Zone Address Ranges