GX-Series Control Panel Installation and Setup Guide6-106Option 58 – KeypadThe keypads connected to the GX-Series control panel can be assigned individual attributes allowing eachkeypad to respond in a particular way. On selecting the Keypad option the details of the first keypadconnected to the system are displayed.GX-077-V0 FLASHING CURSORIF KEYPAD VIEWEDIS THIS KEYPADKEYPAD ADDRESSOPTION2OPTION1OPTION4OPTION3The required keypad is selected by entering the keypad address or by using the A> and keys and thenpressing ent; the keypad displays 1=A-key. Press the A> and keys to select the required option andpress the ent key.NOTE: Wen the address of the keypad currently being used is displayed, a black square flashes on and off overthe first digit of the keypad address.1 = A-keyCode StatusThis option assigns a menu function to the A key. On selecting the option the keypad displays 1 = CodeStatus, this determines the method of operation of the A key:0 = OFF [ ] - A key disabled1 = WITH CODE [+] - A key requires code to be entered prior to operation2 = NO CODE [–]— A key is a single touch operation no code is requiredSelect the required Code Status and press the ent key.NOTE: he Code Status assigned to the key is displayed when selecting the keypad address, forexample A[12]– indicates that the A key does not require a user code.Menu OptionTo assign one of the menu options to the A key, press the A key to move to the 2 = Menu option and pressthe ent key. The keypad displays the currently assigned menu option.GX-078-V0 To assign a new menu function, enter the full menu option number 11 – 71 or press the A> and keysuntil the required menu option is displayed; press the ent key to accept the selection and return to theprevious menu level.2 = B-keyThe programming of the B key is identical to that of the A key.3 = Buzzer MimicThis option determines whether the keypad buzzer mimics the function of the programmed keypadoutput (refer to option 53 = PROGRAM OUTPUTS). The default function of the keypad output isEntry/Exit Horn and the default Mimic defaults to On, therefore the keypad buzzer operates as anEntry/Exit Horn at factory setting.To disable the keypad buzzer from mimicking the output select 0 = Off.4 = BacklightingThis option determines when the keypad backlighting switches on and off.0 = always off,1 = always on (default),2 = on when the system is unset; off when the system is set; switches on when the keys are pressed,
