Honeywell GX-Series Installation And Setup Manual

Contents

Honeywell GX-Series Installation And Setup Manual Manual pdf 22 page image

GX-Series Control Panel Installation and Setup Guide2-14Wiring KeyswitchesLatching or spring loaded keyswitches can be used to set (arm) and unset (disarm) the GX-Series panels;option 52 = PROGRAM ZONES has provision to accommodate both types of transition. If the keyswitchlatches, the transition from 1 k• to 2 k• initiates the setting (arming) procedure of an unset (disarmed)system, the transition from 2 k• to 1 k• instantly unsets (disarms) a set (armed) system. If the system isalready set (armed), then the transition from 1 k• to 2 k• has no effect. If the system is unset (disarmed),the transition from 2 k• to 1 k• has no effect. This is programmed as a * Keyswitch in the PROGRAMZONES option. If the keyswitch is spring-loaded (returns to its normal position), the transition from 1 k• to2 k• initiates the setting (arming) procedure of an unset (disarmed) system and instantly unsets (disarms) aset (armed) system, the transition from 2 k• to 1 k• - the return to the normal position - has no effect. Thisis programmed as a Keyswitch in the PROGRAM ZONES option.Wiring Terminator ButtonsZones programmed as Push-Set (terminator) buttons can be open going closed (2 k• to 1 k•) or closed goingopen (1 k• to 2 k•). The first activation of the terminator button initializes its status to the system.NOTE: The first activation of a terminator may not set (arm) the system as this can be the initialization routine. If thesystem continues setting (arming), push the button again. The system will set (arm) on the second push. Thisinitialization only occurs on the first setting (arming). All subsequent setting (arming) routines set (arm) on thefirst push of the terminator. The wiring of the terminator and keyswitch zone type is shown in Figure 2-16:KeyswitchzonePush-setzone1k to unset (disarm)2k to set (arm)1k 1%Open - Closed1k1k1k1kOR Closed - Open1%1%1%1%GX-016-V21640 ft (500 m)Figure 2-16. Terminator and Keyswitch Zone WiringOutputsThe GX-Series control panel on-board outputs are detailed in the Table 2-9:NOTE: The maximum current draw for the +12V AUX outputs is 1A, and for the switched AUX outputs is 400mA(see TB1 – TB6 in Figure 2-4.) The total maximum load for output addresses 1001, 1003 – 1004 and1011 – 1014 = 400 mA.Output AddressDefaultLine 0Enable Default Function Type RatingNormal State(with 3k3 pull-up)1001 1001 Bells Transistorized 12V, see note above Positive1002 1002 Strobe Single Pole ChangeOver Relay (SPCO)30V, 1A De-energized1003 1003 PA Transistorized 12V, see note above Positive1004 1004 Reset Transistorized 12V, see note above Positive1011 0011 Set Transistorized 12V, see note above Positive1012 0012 Intruder Transistorized 12V, see note above Positive1013 0013 Confirm Transistorized 12V, see note above Positive1014 0014 Reset Transistorized 12V, see note above PositiveTable 2-8. Outputs