89Special Recording Modes4 Press the START/STOP button again to stop recording.• All of the recorded frames are joined together into one clip.• The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing).NOTES• You can use only one special recording mode at a time.• While recording, you cannot change the interval or number of frames.• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.• Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will bedeactivated also if you change the [J Other Functions] [Bit Rate/Resolution] or [Frame Rate] setting.• The time code advances by the number of frames recorded. If the running mode of the time code (0 70) isset to [Free Run] or the time code is input from an external source (b only), the running mode will switchto [Rec Run] during special recording mode. When special recording mode is deactivated, the running modewill return to its previous setting.• b During special recording mode, the time code signal will not be output from the GENLOCK/TCterminal or HD/SD SDI terminal.Frame Recording ModeSet the number of frames in advance. We recommend using the wireless controller or stabilizing the camcorder,for example, on a tripod. Sound is not recorded in this mode.Configuring Frame Recording Mode1 Open the [Rec Frames] submenu.[J Other Functions] [Frame Rec] [Rec Frames]2 Select the desired number of frames and then press SET.• Available options are 1, 3, 6 and 9 (2, 6 and 12 if [J Other Functions][Frame Rate] is set to [24P] or [60P]).Activating Frame Recording Mode and Recording1 Open the [Special Rec] submenu.[J Other Functions] [Special Rec]2 Select [Frame Rec] and then press SET.• [FRM STBY] appears at the top of the screen (with [FRM] flashing).3 Press the START/STOP button to begin recording.• The camcorder automatically records the set number of frames.• The tally lamps illuminate.• [FRM STBY] changes to [N FRM REC] while recording frames and [N FRM STBY] when frames are notbeing recorded.• Repeat until you finish recording.4 Open the [Special Rec] submenu.[J Other Functions] [Special Rec]5 Select [Off] and then press SET.• Frame recording mode ends and all of the recorded frames are joined together into one clip.• The tally lamps go out and [STBY] appears at the top of the screen.[J Other Functions][ Frame Rec][Rec Frames][1][J Other Functions][Special Rec][Off]
