Adding Shot Marks while Recording86Adding Shot Marks while RecordingWhen recording, you can flag an important shot in a clip by adding a “shot mark” (n). There are two types ofshot marks, shot mark 1 (c) and shot mark 2 (d), and you can add either or both types to a single clip. Whenthe camcorder is in mode, you can add or delete shot marks (0 122). You can also display an indexscreen of all the shot marks (0 121), allowing you to find a particular scene in a clip more quickly.To add a shot mark to a clip while recording, you must first set in advance an assignable button to [Shot Mark 1]or [Shot Mark 2]. You can also press the SHOT1 button on the wireless controller to add the c mark.1 Set an assignable button to [Shot Mark 1] or [Shot Mark 2] (0 97).• To add both shot marks, set one assignable button to [Shot Mark 1] and another assignable button to [ShotMark 2].2 While you are recording, press the assignable button at the beginning of the shot you wish to mark.• A message indicating the short mark will appear and the selected shot mark will be added to the currentframe of the clip.• You can press the button again to add another shot mark. Up to 100 shot marks (c and d markscombined) can be added to a single clip.NOTES• There may be up to a 0.5 second delay from when you press the button to when the camcorder adds the shotmark.• When you are using interval recording or frame recording mode, you cannot add shot marks to a clip.• When a clip contains either shot mark, n will appear next to the clip’s thumbnail in the playback index screen.Operating modes:
