1246 External ConnectionsVideo Output ConfigurationThe video signal output from the HD/SD SDI (b only), HDMI OUT and HD/SD COMPONENT OUTterminals depends on the clip’s video configuration, the capability of the external monitor (for video output fromthe HDMI OUT terminal) and on various menu settings. Video output from the AV terminal will always be in 480/60i standard.Video Output Configuration by TerminalRefer to the following table for the video output configuration from each terminal. If necessary, you cansuperimpose the onscreen displays on the video displayed on the external monitor (0 128).NOTES• b When the camcorder is connected via HDMI OUT terminal to an external monitor, the video signaloutput from the HD/SD SDI terminal will be the same as that from the HDMI OUT terminal.Operating modes:Video Output Configuration by Terminal1 Set [N Video Setup] [SDI Output] to [HD], [SD] or [Off].2 When you set [M LCD/VF Setup] [HD Output] (under [Zebra]) to [On], you can display zebra patterns on an external monitor.In such case, output from the HD/SD SDI terminal (b only) and HD/SD COMPONENT OUT terminal will be in HD, regard-less of their setting.3 Video output will automatically switch to HD or SD, depending on the capability of the external monitor.4 Set [N Video Setup] [Component Output] to [HD] or [SD].5 When output from the HDMI OUT terminal is SD (480/60P), the output of the HD/SD SDI terminal will also be 480/60P.Terminal J HD/SD SDI1, 2(b only) HDMI OUT 2, 3 HD/SD COMPONENTOUT 2, 4 AVRecording framesize / Frame rate LHDoutputSDoutputHDoutputSDoutputHDoutputSDoutputSDoutput1080/60i1080/60i 480/60i5 1080/60i 480/60P 1080/60i 480/60i 480/60i1080/30P1080/24P1080/slow orfast motion720/60P720/60P 480/60i5 720/60P 480/60P 720/60P 480/60i 480/60i720/30P720/24P720/slow orfast motion
