Canon XF100 Instruction Manual

Also see for XF100: User guide Instruction manual Instruction manual

Contents

Canon XF100 Instruction Manual Manual pdf 164 page image

Troubleshooting164Horizontal bands appear on the screen.- This is a phenomenon typical of CMOS image sensors when recording under some types of fluorescent, mercury orsodium lamps. To reduce the symptoms, set [Camera Setup] [Flicker Reduction] to [Automatic] (0 57) or set theshutter speed to 1/100 (0 56). This is not a malfunction.Audio cannot be recorded.- The AUDIO IN switch is not set correctly (0 77).- An external microphone connected to the XLR terminal requires phantom power. Set the XLR terminal switch toMIC+48V (0 79).Audio is recorded at an extremely low level.- The audio level switch is set to M, and the recording level is set too low. Check the audio level meter on the LCDscreen and adjust the audio level correctly (0 81).- The microphone attenuator is on. Turn off the microphone attenuator of the built-in microphone or externalmicrophone (0 78).Sound is distorted or is recorded at lower levels.- When recording near loud sounds (such as fireworks, shows or concerts), sound may become distorted or it may notbe recorded at the actual levels. Activate the microphone attenuator of the built-in microphone or external microphone(0 78), or adjust the audio recording level manually.The picture is displayed correctly but there is no sound from the built-in speaker.- Speaker volume is turned off. Adjust the volume (0 115).- If headphones are connected to the camcorder, disconnect them.Recording Media and AccessoriesCannot insert the recording media.- The CF card or SD card you are trying to insert is not facing the correct direction. Turn it over and insert it.Cannot record on the CF card.- A compatible CF card must be used (0 35).- Initialize the CF card (0 37) when you use it with the camcorder for the first time.- The CF card is full or it already contains the maximum number of clips (999 clips). Delete some clips (0 120) to freesome space or replace the CF card.Cannot record on the SD card.- Initialize the SD card (0 37) when you use it with the camcorder for the first time.- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.- The SD card is full. Delete some photos (0 141) to free some space or replace the SD card.- The folder and file numbers have reached their maximum value. Set the [Other Functions] [Photo Numbering]setting to [Reset] and insert a new SD card.Recording to and playing back from a CF card is slow.- This may occur as video is recorded/deleted over time. Save your clips (0 131) and initialize the CF card (0 37).Recording to and playing back from an SD card is slow.- This may occur as photos are recorded/deleted over time. Save your photos and initialize the SD card (0 37).The wireless controller will not work.- Set [Other Functions] [Wireless Controller] to [On].- Replace the battery of the wireless controller.Connections with External DevicesVideo noise appears on a nearby TV screen.- When using the camcorder in a room where a TV is located, keep a distance between the compact power adapter andthe power or antenna cables of the TV.Playback looks fine on the camcorder but there is no image on the external monitor.- The camcorder is not connected correctly to the external monitor. Make sure you are using the correct connection(0 126).- The video input on the external monitor is not set to the video terminal to which you connected the camcorder. Selectthe correct video input.