Troubleshooting168File name error- The folder and file numbers have reached their maximum value. Set 8[Photo Numbering] to [Reset] and delete all the photos on the memory card (0 130) orinitialize it (0 40).Initialize only using the camcorder- There is a problem with the file system that prevents accessing the selected memory. Initializethe memory with this camcorder (0 40).LCD Screen has been dimmed- Hold h pressed for 2 seconds to restore the LCD screen to its previous brightness setting.May not be possible to record movies on this memory card- You may not be able to record movies on a memory card without a Speed Class rating.Replace the memory card with one rated SD Speed Class 2, 4, 6 or 10.Mem. Card Number of scenes already at maximum- The memory card already contains the maximum number of scenes (3,999 scenes); no furtherscenes can be copied onto the memory card. Delete some scenes (0 98) to free some space.Mem. Card Unable to recognize the data- The memory card contains scenes recorded using a video configuration that is not supported(PAL or SECAM). Play back the recordings in the memory card with the device originally usedto record them.Memory card cover is open- After inserting a memory card, close the double memory card slot cover.Memory card is full- The memory card is full. Delete some recordings (0 98, 130) to free some space or replacethe memory card.Memory card is write-protected- The LOCK switch on the memory card is set to prevent accidental erasure. Change the positionof the LOCK switch.Need to recover files from the memory card. Change the position of the LOCK switch on thememory card.- This message will appear the next time you turn on the camcorder if power supply wasaccidentally interrupted while the camcorder was writing on the memory card and later theposition of the card's LOCK switch was changed to prevent erasure. Change the position of theLOCK switch.No memory card- Insert a compatible memory card into the camcorder (0 37).No photos- There are no photos to play back.No scenes- There are no scenes in the memory selected.Not enough available space- Delete some recordings on the memory card (0 98, 130) or select the [3 Mbps] bit rate for theconversion to SD.Number of scenes already at maximum- The maximum number of scenes (3,999 scenes) has been reached. Delete some scenes(0 98) to free some space.
