Capturing Video Snapshot Scenes and Photos from a Movie104Capturing PhotosYou can capture a single photo or a series of photos. The size of the captured photos will be1920x1080 and it cannot be changed.Please read the IMPORTANT section (0 104) before using an Eye-Fi card.To select the photo capture settings1 Open the [Photo Capture from Video] screen.[MENU] 8 [Photo Capture from Video]2 Touch [A Single Photo] or [B Photo Sequence] and then touch [a].To capture the photos1 Play back the scene or story from which you want to capture the photo.2 Pause the playback at the point you want to capture.3 Touch [PHOTO].• To capture a photo sequence, keep touching [PHOTO]. The scene will be played back frame-by-frame and each frame captured as a separate photo.4 Touch [B] to stop the playback.IMPORTANT• When capturing photos on an Eye-Fi card in memory card slot Y, photos will be uploadedautomatically if you are within the range of a configured network. Always verify that Eye-Fi cardshave been approved in the country/region of use. See also Using an Eye-Fi card (0 142).NOTES• The data code of the photos will reflect the date and time of recording of the original scene.• Photos captured from a scene with a lot of fast movement may be blurred.• Photos will be recorded on the memory selected for recording photos.• [B Photo Sequence]:- Up to 100 photos can be captured at a time.- The photo sequence capture will stop when the end of the scene is reached (playback will pauseat the beginning of the following scene).- Photos will be captured at intervals of 1/30 second (1/24 second, if the scene was recorded at aframe rate of [E PF24] or [ 24P]).
