Canon XA10 User Manual

Also see for XA10: User guide Brochure & specs Brochure & specs Study guide Quick guide

Contents

Canon XA10 User Manual Manual pdf 167 page image

Troubleshooting167Cannot save the canvas- Cannot save your [Pens and Stamps] drawings on the memory. Save your recordings (0 135)and initialize the memory (0 40).Cannot use IR mode during Cinema mode. Change the camcorder's mode to y or .- Infrared recording is not available in mode. Change the camcorder to ormode.Change the battery pack- Battery pack is exhausted. Replace or charge the battery pack.Check the memory card- Cannot access the memory card. Check the memory card and make sure it is insertedcorrectly.- A memory card error occurred. The camcorder cannot record or display the image. Tryremoving and reinserting the memory card, or use a different memory card.- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card(0 36).- If after the message disappears, 4/7 appears in red, perform the following: Turn off thecamcorder and remove and reinsert the memory card. If 4/7 turns back to green you canresume recording/playback. If the problem persists, save your recordings (0 135) andinitialize the memory card (0 40).Do not disconnect the power source. Cannot write data with this connection. To write data tothe camcorder, connect the compact power adapter then reconnect the camcorder andcomputer. Do not disconnect the USB cable unless you first use the computer to safely endthe connection.- The camcorder cannot be operated while it is not being powered by the compact poweradapter and is connected to a computer with the supplied USB cable. In addition, scenescannot be written back and music files cannot be transferred to the camcorder. To avoidcorrupting the data in the camcorder’s memory, use the computer’s Safely Remove Hardwarefunction to end the connection and disconnect the USB cable before using the camcorder.- To be able to write back scenes and to transfer music files to the camcorder, use thecomputer’s Safely Remove Hardware function to end the connection, disconnect the USBcable, power the camcorder using the compact power adapter and only then connect it to thecomputer again.Do not disconnect the power source. Do not disconnect the USB cable unless you first usethe computer to safely end the connection.- When the camcorder is in mode and is connected to the computer with the supplied USBcable, the camcorder cannot be operated. Disconnecting the USB cable or power source whilethis message appears may result in permanent loss of the recordings in the camcorder. Use thecomputer's Safely Remove Hardware function to end the connection and disconnect the USBcable before using the camcorder.- To be able to write back scenes and to transfer music files to the camcorder, power thecamcorder using the compact power adapter and only then connect it to the computer usingthe supplied USB cable.Error writing on the memory card. Data may be recovered if the memory card has not beenremoved. Attempt recovering the data?- This message will appear the next time you turn on the camcorder if power supply wasaccidentally interrupted while the camcorder was writing on the memory card. Select [Recover]to try to recover the recordings. If you removed the memory card and used it with anotherdevice after this happened, we recommend you select [Give Up].