COPYRIGHT © 1999 CANON INC. CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)2. Removing the Heat Discharge Fan(FM2; printer unit)1) Perform the steps on p. 3-16 toremove the rear cover.2) Disconnect the connector, and disen-gage the two claws; then, detach theheat discharge fan 2.q Connector w Clawe Heat discharge fan 2Figure 7-4053. Removing the Heat Discharge Fan(FM3; printer unit)1) Perform steps 1) through 5) on p. 3-18to remove the right cover together withthe fan duct.2) Disengage the two claws, and detachthe duct cover.q Claws w Duct coverFigure 7-4063) Slide the heat discharge fan 3 by slid-ing it upward.q Heat discharge fan 3Figure 7-407CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS7-11When mounting the heat dischargefan, be sure that the logo of the manu-facturer is toward the outside of theprinter unit.Caution:When mounting the heat dischargefan, be sure that the logo of the manu-facturer is toward the outside of theprinter unit.Caution:eqwqwqDownload free service manual at http://printer1.blogspot.com
