Check 4: Is the message "This document failed to print" displayed?Do not retry printing. Check the error message on the LCD.Clear the error according to An Error Message Is Displayed on the LCD .When you use a Microsoft Bluetooth driver, make sure that the Printing (HCRP) service iseffective on your computer.Click Control Panel, Bluetooth Devices under Hardware and Sound (Printers and OtherHardware in non-Vista Windows), then select the printer to be used for Bluetoothcommunication and click Properties.Make sure that Printing (HCRP) on the Services sheet is checked.If Printing (HCRP) is not checked or the Printing (HCRP) service is not detected, follow theprocedure below and register the printer again.1. Click Control Panel, then Printers under Hardware and Sound.When using non-Vista Windows, click Control Panel, then Printers and Faxes under Printersand Other Hardware.2. Click the icon of the printer for printing via Bluetooth communication.3. Select Delete from the Organize (File in non-Vista Windows) menu.4. Authenticate the printer as a Bluetooth device on Bluetooth Devices in ControlPanel.For more information about the procedure, see Registering the Printer .This message is displayed when the print job is sent from the Bluetooth device while anotherprint job through the USB port is being printed out.Printing will begin automatically when the print queue is finished.Printing cannot be carried out with Bluetooth communication from more than one computer atthe same time. In this case, this message is displayed on the computer during standing by.Printing will begin automatically when the print queue is finished.Check 5: Were the MP Drivers installed after printer registration onBluetooth Devices?If you have installed the MP Drivers after registering the printer as a Bluetooth device on BluetoothDevices, delete the printer and then register it again.For more information about the procedure, see Preparation.Page topPage 641 of 815 pagesPrinting Does Not Start
