DocuMate 252 Scanner User’s Guide 61Scanning14. Now click the arrow buttons to select a scanner button for eachnew configuration. Click Apply to set that button for thatconfiguration.The following examples show that buttons 7 and 8 have beenset to scan to each of the new configurations.Note that the button names have also been changed to Storage1 and Storage 2 to remind you that both send documents tostorage, but to different locations. To change button names,see “Renaming a One Touch Button” on page 47.Scan to multiple storage folders:1. Insert the documents you want to scan to storage.2. Press the Destination Selector buttons on the scanner to getto one of the buttons set up for scanning to storage.3. Press the Simplex or Duplex button to scan the documents.4. When scanning is finished, insert the next set of documentsand press the Destination Selector buttons to get to the nextbutton you have set up for scanning.5. Press the Simplex or Duplex button to scan the documents.When scanning is finished, the two sets of documents are stored intwo separate folders.Editing or Deleting Scan ConfigurationsNOTE: Your scanner comes with a number of configurationspre-set at the factory. We recommend that you keep thoseconfigurations locked and do not edit or delete them. That way,you will always have the factory-settings available. If you do editor delete them, and want to get the factory pre-sets back again,you will need to uninstall then re-install your scanner.
