Toshiba 2000 V Series Manual

Also see for 2000 V Series: User manual

60 model 2000 DeviceNet Module Manual (DN611/DN611A)Chapter 4 Operating Procedures for the DN611 (Software)4Table 4-3 Examples of DN611 Modes and Station StatusesDN611 mode Bit to turn 1 Station statusa Down mode DOWN 8000Hb After switching power on or after issuing a resetrequest from the S controllerSTBY 2000Hc Slave device is not registered in the DN611, or isdeleted from it, in mode b).STBYNCOIN2040Hd Slave device is registered by a parameter settingrequest in mode c).STBY 2000He Standby is requested by a module control requestfrom the S controller.STBY 2000Hf Transmission enable, polling mode transmission,asynchronous mode are requested by a modulecontrol request from the S controller and transmissionis under way innormal condition.RUNSTARTPOLL1210Hg Transmission enable, bit strobe mode transmission,asynchronous mode arerequested by a modulecontrol request from the S controller and transmissionis under way in normal condition.RUNSTARTBITS1410Hh Transmission enable, transmission in polling modeand bit strobe mode, asynchronous mode arerequested by a module control request from the Scontroller and transmission is under way in normalcondition.RUNSTARTPOLLBITS1610Hi Synchronous mode is requested in cases f) to h). SYNC in addition tothe bits for f) to h)1218H1418H1618Hj Response from slave device has ceased duringcommunication with it in the modes specified in f) to i).TXERR in additionto the bits for f) to i)1230H1430H1630H1238H1438H1638Hk The DN611's DIP switch (BUSOFF) is at OFF when abusoff has occurred. (DN611 has control of restartingtransmission.)BUSOFF in addition to the stationstatus bits preceding the busoff.l The DN611's DIP switch (BUSOFF) is at ON when abusoff has occurred. (DN611 is set in standby modedue to the busoff.)STBYBUSOFF2004Hm A duplicate node address is detected when startingtransmissionSTBYDPADR2002H