Toshiba 2000 V Series Manual

Also see for 2000 V Series: User manual

6F8C0845 1155.4 Other Functions5(3) Explanations(a) Allocation confirmation• This function is valid in run mode only.• The start relay INSTRUCT is turned TRUE to start operation.• Values for CH, UNIT, and SLOT are entered using the variables (CH, UNIT,SLOT) set by an initialize request. A node address for allocation confirma-tion is entered for NODE (1 in the above example).• Calculation results of allocations are output to BS_ADD, BS_N, RPOL_ADD,RPOL_N, WPOL_ADD, and WPOL_N.• When the calculation is completed, the end confirmation coilEND_INSTRUCT becomes TRUE.(b) RAS information read request• This function can be used in other than initialize mode.• The start relay RASREAD is turned TRUE to start operation.• Values for CH, UNIT, and SLOT are entered using the variables (CH, UNIT,SLOT) set by an initialize request.• The RAS information specified by REQTYPE, POSITION, and N is output toREAD_DT.• When the output is completed, the end confirmation coil END_RASREADbecomes TRUE.(c) Time setting request• This function can be used in other than down mode and initialize mode.• The start relay TIMESET is turned TRUE to start operation.• Values for CH, UNIT, and SLOT are entered using the variables (CH, UNIT,SLOT) set by an initialize request.• In the above example, the system time data (SW[16] to SW[21] is entered astime setting parameter to set the same time as that of the controller.• When the output is completed, the end confirmation coil END_TIMESETbecomes TRUE.