4-4Positional Deviation Measurement41REGISTER NO.2MEAS SHAPE(MDL0)3SEARCH AREA(MDL0)4DTECT MODE(MDL0)5SEARCH DIR(MDL0)6THRESHOLDS(MDL0)7REF COORD(MDL0)F C1 BRTSELECT OBJECT TYPE COND COLOROBJECT TYPE CONDTYPE00TYPE01TYPE RUN CONDIMAGE-ADJMEA-CND(CAMERA1)MEAS0(POSI-DEVIATION F)IMG PRE-PROCMEAS CNDREG-COND(S)REG-COND(E)EVALUATION CONDDISTANCE&ANGLE CONDNUM-CALCOUT-CONDPOSI-CORRECTMEAS(NEW)MEA-CND(CAMERA2)FINAL NUM. CALCFINAL OUTPUT CONDOBJ-TYPE I/OOBJ-TYPE SYS.SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUPHow to set the register conditionsHow to enter the REG-COND setting screenThere are three methods for getting to the REG-COND setting screen.1) On the MEAS CND setting screen, move thecursor to " MDL 0" or " MDL 1" and pressthe SET key. The cursor will move into thetable. Move the cursor to the "S" or "E" columnand press the SET key.Note: If you press the SET key in the "X"column, the setting will be invalid.2) On the MEAS CND setting screen, press theTRG/BRT key to move the cursor to the upperfunction menu. Select the "COND" item andthen select the "REG-COND(S)" or "REG-COND(E)" item and press the SET key.3) On the menu tree, move the cursor to the"MEAS CND" item, and press the right arrowkey. The sub menu which contains the "REG-COND(S)" and "REG-COND(E)" items willappear. Move the cursor to either of these itemsand press the SET key.1DTECT PRECISION STANDARD2REGISTER NO. 0(0~7)3MODE 1P-SCH+1P-EDGE4DTECT ANGL NOREGISTER NO.5MDL 06MDL 115141312111009080706050403020100SF C1 BRTSET=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNCIMG PRE-PROCREG-COND(S)REG-COND(E)EVALUATIONDST&ANGLNUM-CALCOUTMEAS CND SCREEN COND SAVE BLUE
