Setting the Conditions for Each Object Type3-533[5] Halt on NG measurementYou can stop all measurements when an NG image(according to the final evaluation results) occurs whileoperating the IV-C35M.Select " HALT ON NG MEAS" on the "OBJECTTYPE SYS." menu.Shown below is an example of an NG image that occurred during measurement 1.NG occurred(Setting whether to stop measurements when an NG occurs)"No" "Yes"Wait for trigger inputProcessing measurement 0, camera 1Processing measurement 0, camera 2Processing measurement 1Processing measurement 2Processing measurement 3Processing measurement 4- Stops processesof measurements 2to 4NOYESNO(NG MEAS DISP)1REGST NG IMG YES2HALT ON NG MEAS YES3MNTR LIGHT LVL(CAM1) YES4LIGHT LV COND (TO NEXT SUB-BENU)5MNTR LIGHT LVL(CAM2) YES6LIGHT LV COND (TO NEXT SUB-MENU)7MOVE ALL WINDOW (TO NEXT SUB-MENU)OBJ-TYPE SYS. SCREEN SAVE COLOR F C1 BRT22222HALT ON NG MEAS DescriptionNOEven if an NG image (final evaluation result) is detected whileoperating the IV-C35M, the system will continue makingmeasurements.YESWhen an NG image is detected (according to the finalevaluation result) while operating the IV-C35M, the controllerwill stop making measurements.NO(NG MEAS DISP)Even if an NG image (final evaluation result) is detected whileoperating the IV-C35M, the system will continue makingmeasurements. But, it displays the occurred NGmeasurements at first.
