Samsung OfficeServ 7200 Technical Manual

Also see for OfficeServ 7200: System administration guide User guide User instruction User guide User manual

Contents

MANUAL RETRY WITH REDIALWhile you are on an outside call listening to a busy signal and you want to redialthe same number dialed.• Press the REDIAL button.This will hang up your existing call and manually redial the same number dialed.You can repeat this operation for a limited number of attempts.NOTE: If your keyset is programmed with Call Log Blocks then the Redial willaccess the call log when pressed.SAVE NUMBER WITH REDIALTo save the number you just dialed for later use, press the SNR button beforehanging up.To redial this saved number at any time, press the SNR button or dial 17.The sameline will be selected for you.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.2. The saved telephone number is stored in memory until you save anothernumber.3. Redial does not apply to intercom calls.CHAIN DIALINGYou may manually dial additional digits following a speed dial number or chain asmany speed dial numbers together as required:• After the first speed number is dialed, press MEMORY again and dial anotherspeed number OR manually dial additional digits following a speed dial num-ber.AUTOMATIC REDIAL/RETRYWhen you are making an outside call and you receive a busy signal, the systemcan automatically redial the number for you. It will automatically redial at a pre-programmed interval for up to 15 attempts.• When you hear a busy signal, press the RETRY button.• The system will reserve the line and automatically redial the same number foryou.You will hear the call being made through the keyset speaker.The micro-phone is muted.31For the purposes of pro-gramming speed dial num-bers, the programmable but-tons are known as A, B, C, D, Eand F.• The A button is not used.• The B button inserts aflash.• The C button inserts apause.• The D button is used forpulse to tone conversion. If your system uses rotary (or pulse) dialing C.O. lines,pressing D while entering a speed dial number causes all subsequent digits tobe sent as DTMF tones.• The E button is used to hide digits. Display keyset users may want to hidesome speed dial numbers so that they will not show in the display. When youare entering a telephone number, press E. All subsequent digits will be hid-den. Press E again to begin displaying digits.• The F button is used to enter a name. See Personal Speed Dial Names underDisplay Features.• Use the HOLD button to clear a speed dial number.ONE TOUCH SPEED DIALINGYou may assign any speed dial number to an already existing One Touch SpeedDial button for quick and easy dialing of frequently used numbers.• While on-hook, press TRANSFER and then dial 107.• Press a One Touch Speed Dial button.• Dial the speed dial number (00–49 or 500–999) that you want assigned tothis button.• Press TRANSFER to store your selection.To call this telephone number, just press the One Touch Speed Dial button.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.LAST NUMBER REDIALTo redial the last telephone number you dialed, press the REDIAL button or dial 19.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.2. Redial does not apply to intercom calls.30A B C D E F