Samsung OfficeServ 500 User Instruction

Also see for OFFICESERV 500 Series: Service manual System administration guide Quick setup guide Quick setup guide Quick setup guide

Contents

SET ANSWER MODE (INTERCOM)You can receive internal calls in one of three modes (see Answering Intercom Callsunder Intercom Calls for descriptions).• While on-hook, press TRANSFER and then dial 103.• Dial 0 for Ringing, 1 for Auto Answer or 2 for Voice Announce.• Press TRANSFER to store your selection.From the LCD:• Press MENU button.• Scroll to SETUP option and press ENTER.• Scroll to ANSWERING MODE and press ENTER—OR—you may dial 1 andimmediately enter the option.• Select desired station ring type setting. (Ring, Auto Answer, or VoiceAnnounce).• Press ENTER to select and SAVE.• Press CANCEL to return to the Main Option Page—OR—press END to returnto idle screen.NOTE: When your keyset is programmed for Auto Answer and you have ForwardNo Answer (FNA) turned on, you must answer screened transfers by pressing theSEND button before your FNA timer expires or the call will forward.SET ANSWER MODE (CO)Your incoming CO calls can be set to follow the intercom answer mode.• While on-hook, press TRANSFER and then dial 110.• Dial 15 to access AUTO ANS CO.• Press the VOLUME UP or DOWN key to change status.• Press TRANSFER to store your selection.AUTOMATIC HOLDWhile on an outside call, pressing a line button, route button or a flashing CALLbutton will automatically put your call on hold and connect you to the next call.This feature can be turned on or off at your keyset.• With the handset on-hook, press TRANSFER and then dial 110.• Dial 001 to turn Automatic Hold on or 000 to turn it off.• Press TRANSFER to store your selection.5150SELECT RING TONEEach ITP-5112L user can select from a variety of ring tones.From the LCD:• Press MENU button.• Scroll to SOUND/SCREEN option and press ENTER.• Scroll to RING TONE SELECT and press ENTER—OR—you may dial 1 andimmediately enter the option.• Select from one of the three categories:1. Standard Ring Tones2. Melody or3. My Ring Tones• Press ENTER to select. Use LEFT/RIGHT arrow buttons to scroll through theavailable ring tones and press ENTER to SAVE.• Press CANCEL to return to the Main Option Page—OR—press END to returnto idle screen.CHANGE YOUR PASSCODEFrom the factory, your station passcode is 1234.You can change your station pass-code whenever you desire.• While on-hook, press TRANSFER and then dial 101.• Dial your old passcode.• Dial a new passcode (must be four characters). You can use 0–9.• Redial the new passcode to verify. If successful, you will hear two beeps. Fourbeeps indicate an incorrect code. Reenter the code again.• Press TRANSFER to store the new passcode.From the LCD:• Press MENU button.• Scroll to MY PHONE option and press ENTER.• Scroll to CHANGE PASSWORD and press ENTER—OR—you may dial 3 andimmediately enter the option.• Enter CURRENT PASSWORD, press ENTER.• Enter NEW PASSWORD and press ENTER.• Enter NEW PASSWORD again, for confirmation and press ENTER.• Press CANCEL to return to the Main Option Page—OR—press END to returnto idle screen.