NAVIGATING THE MENUSOnce the IP setup menu is displayed, you can move to each menu by using thebuttons as described below:• The [0]~[9] dial buttons are used to directly choose a menu, or sub-menuoptions.• The volume []~[] buttons are used to move the cursor up or down toscroll through menu items.• The SPEAKER button is used to select a menu item or to save data after entry.It functions as an “ENTER” or “OK” button.• The HOLD button will take you out of the current sub-menu to one menulevel up to previous screen. It functions as an “ESCAPE” or “CANCEL” button.• In some entry fields, the HOLD button is used to backspace the cursor or todelete entered data.• The [] button on the dial pad is used to enter [] between IP address octets.9>1.SYSTEM EASY WIZARD2.SYSTEM INFORMATION3.NETWORK SETUP4.LOAD & UPGRADE SETUP5.SYSTEM SERVER SETUP6.FACTORY RESET8ITP-5107S SETUPINITIALIZING THE ITP-5107SInitially the ITP-5107S IP keyset will need to be setup to operate within the usersnetwork.The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen via scroll key willbe highlighted.The station numbers will be automatically set by the OfficeServ 100, OfficeServ500, and the OfficeServ 7000 Series systems once the necessary information hasbeen entered into the IP keyset. Enter ID and password of the server, as describedbelow to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the ITP-5107S are:• IP Address of the ITP• Network Gateway Address• Subnet Mask• IP Address of System’s MCP• User ID• PasswordSETUP MENUTO GET TO THE SET-UP MENU, UNPLUG THE POWER FROM THE ITP-5107SPHONE OR UNPLUG THE LAN CABLE IF USING POWER OVER ETHERNET,PRESS AND HOLD THE BUTTON ON THE DIAL PAD WHILE PLUGGING IN THEPOWER CORD OR LAN CABLE IF USING POWER OVER ETHERNET BACK INTOTHE PHONE. NOW RELEASE THE BUTTON.Other items not shown on screen when scrolling down.6.FACTORY RESET7.REBOOT
