Samsung DCS Programming Manual

Also see for DCS: User guide Programming manual Quick reference guide User guide Guide

Contents

SAMSUNG MMC PROGRAMSCOMBINED SYSTEMS PROGRAMMING MANUAL FEBRUARY 2004MMC 105 (Page 1 of 2)MMC: 105 STATION SPEED DIALFOR: ALL SYSTEMSPurpose: Programs personal speed dial numbers for stations. This may be particularlyuseful for single line telephones which are more difficult to program by the station user.By default, each station has one block of speed dial locations or “bins” (numbered 00–09) assigned to it. One block can hold up to 10 numbers. However, each station canhave up to five blocks of speed dial locations assigned to it—in MMC 606, Assign SpeedBlock—giving a total of 50 numbers (00–49).Each speed dial may contain a trunk or trunk group access code (e.g. 9) followed by aseparator (–) and up to 24 digits to be dialled. These dialled digits can be 0–9, 4 and #. Ifthe system recognises a valid trunk or trunk group access number, it will automaticallyinsert the separator.The following keys can also be used:“B” Insert a flash code “F””C” Insert a pause code “P””D” Insert a pulse/tone conversion code “C””E” Mask/unmask following digits (shows as “[“ or “]”)”F” Enter name for speed dial bin (see MMC 106)(Refer to section 1.5.2 in Part 1 for key descriptions.)ACTION DISPLAY1. Open programming and select 105Display shows[201] SPEED DIAL00 :2. Dial station number (e.g. 205)OR[205] SPEED DIAL00 :Press VOLUME keys to select station and pressRIGHT soft key to move cursorIf selected station has no speed dial blocks as-signed, the display will be as shown and a new[205] SPEED DIALNO SPEED BLOCKstation may be selected.3. Enter speed dial number (e.g., 05)OR[205] SPEED DIAL05: _Press VOLUME keys to select location and pressRIGHT soft key to move cursor4. Enter trunk access code (e.g., 9) followed by thenumber to be dialled (e.g., 08104264100)[205] SPEED DIAL05 : 9-08104264100_If you make an error, press the HOLD key to clearan entire entry or use the VOLUME (Down) key tomove the cursor back and enter correct number