Panasonic WV-SW390 Series Operating Instructions Manual

Also see for WV-SC384: Integration note Product catalog Installation guide Operating instructions Operating instructions

Contents

Panasonic WV-SW390 Series Operating Instructions Manual Manual pdf 135 page image

[Image capture size]Select the capture size of images to be transmitted to the FTP server or of an image to be attached to thealarm mail.When “4:3” is selected for “Aspect ratio”SC384QVGA/ VGA/ 1280x960When “4:3 (VGA)” is selected for “Aspect ratio”SW396SW395SC386SC385QVGA/ VGA/ 1280x960When “4:3 (800x600)” is selected for “Aspect ratio”SW396SW395SC386SC385QVGA/ 800x600/ 1280x960When “16:9” is selected for “Aspect ratio”320x180/ 640x360/ 1280x720• Default: VGA[Image compression rate upon alarm detection]Select “On” or “Off” to determine whether or not to change the image quality of “Quality1” (®page 76) uponalarm detection.• On: Images will be transmitted with the image quality selected for “Image quality upon alarm detection”.• Off: Does not change the image quality upon alarm detection.• Default: Off[Image quality upon alarm detection]Image quality can be changed upon an alarm occurrence. Select the image quality from the following.0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low• Default: 5 Normal13.4 Configure the settings relating to H.264recording [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 43, page 45)The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can beconfigured on this page. To operate recording, it is necessary to configure the settings relating to SD memorycard and the video data. (®page 54)H.264 recording (SD memory card)[Pre alarm]Determine whether or not to perform the pre alarm recording. When “Use” is selected, 1 MB image data isalways saved during the pre alarm recording.Use/ Not use• Default: Not useOperating Instructions 13513 Configure the alarm settings [Alarm]