• Default: Off[Terminal alarm 3]Select an action to be taken when a terminal alarm 3 is detected from the following.• Off: Does not take any action even when a terminal alarm 3 is detected.• 1-64SW395SC385SC384 : When the registered preset position is selected, the camera will moveto the selected preset position when a terminal alarm 3 is detected.• Auto trackSW395SC385 : When a terminal alarm 3 is detected, the camera will start the auto tracking.• 1-256SW396SC386 : If a previously registered preset position is selected, when a terminal alarm 3 isdetected, the camera will move to that position.• Auto trackSW396SC386 : When a terminal alarm 3 is detected, the camera will start the auto tracking.• Patrol 3SW396SC386 : When a terminal alarm 3 is detected, the camera will start the patrol.* If Patrol 3 is not registered it is not displayed on the screen.• Default: Off[VMD alarm]Select an action to be taken when a VMD alarm is detected from the following.• Off: Does not take any action even when a VMD alarm is detected.• 1-64SW395SC385SC384 : When the registered preset position is selected, the camera will moveto the selected preset position when a VMD alarm is detected.• Auto trackSW395SC385 : When a VMD alarm is detected, the camera will start the auto tracking.• 1-256SW396SC386 : If a previously registered preset position is selected, when a terminal alarm 1 isdetected, the camera will move to that position.• Auto trackSW396SC386 : When a VMD alarm is detected, the camera will start the auto tracking.• Patrol 1SW396SC386 : When a VMD alarm is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.• Default: Off[Command alarm]Select an action to be taken when a command alarm is detected from the following.• Off: Does not take any action even when a command alarm is detected.• 1-64SW395SC385SC384 : When the registered preset position is selected, the camera will moveto the selected preset position when a command alarm is detected.• Auto trackSW395SC385 : When a command alarm is detected, the camera will start the auto tracking.• 1-256SW396SC386 : If a previously registered preset position is selected, when a terminal alarm 1 isdetected, the camera will move to that position.• Auto trackSW396SC386 : When a command alarm is detected, the camera will start the auto tracking.• Patrol 1SW396SC386 : When a command alarm is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.• Preset per senderSW396SC386 : By registering the sender's address for the command alarm andthe preset position for that address, the camera will move to the preset position when an alarm is detectedfrom the command alarm.Click “Preset per sender >>” to open a separate window for setting preset positions for alarms.(®page 132)• Default: Off13.2.1 Configure the settings relating to Preset per sender (“Presetper sender” setup menu) (WV-SW396/WV-SC386)On the [Alarm] tab (®page 130), click “Preset per sender >>” for “Command alarm”.132 Operating Instructions13 Configure the alarm settings [Alarm]
