– High: Switches from the color mode to the black & white mode when the ambient brightness (illuminance)of the camera is approx. 6 lx or less.– Low: Switches from the color mode to the black & white mode when the ambient brightness (illuminance)of the camera is approx. 2 lx or less.When “Day & Night(IR)” is set to “Auto3”– High: Carries on the color mode by activating the super chroma compensation function when the ambientbrightness (illuminance) of the camera is approx. 6 lx or less.When the color temperature of the object becomes approx. 3,500 K or lower, the color mode will beswitched to the black & white mode.– Low: Carries on the color mode by activating the super chroma compensation function when the ambientbrightness (illuminance) of the camera is approx. 2 lx or less.When the color temperature of the object becomes approx. 3,500 K or lower, the color mode will beswitched to the black & white mode.• Default: High[Dwell time]Select a wait time for switching between the color mode and the black & white mode from the following.2s/ 10s/ 30s/ 1min• Default: 10s[White balance]Select a method of white balance adjustment from the following.White color can be adjusted by “Red gain” and “Blue gain”.• ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the colortemperature of the light source and adjust the white balance automatically. Operating color temperaturerange is approx. 2,700 K to 6,000 K.• ATW2: Selects the automatic tracing white balance mode under a sodium lamp. The camera will adjustthe white balance automatically under a sodium lamp. Operating color temperature range is approx. 2,000K to 6,000 K.• AWC: Selects the automatic white balance control mode. This adjustment is suitable for a location wherea light source is stable. Operating color temperature range is approx. 2,000 K to 10,000 K.• Default: ATW1Note• Under the following conditions, color may not be faithfully processed. In these cases, select “AWC”.– When shooting a subject whose major part is a thick color– When shooting blue sky or sun at sunset– When shooting a subject whose luminance is too low• When “AWC” is selected, click the [Set] button.[Red gain]Adjust the red color of images.When the cursor is moved in the “+” direction, the red color will become thicker. When the cursor is moved inthe “-” direction, the red color will be thinner. Click the [Reset] button to reset the color to the default.• Default: 128[Blue gain]Adjust the blue color of images.When the cursor is moved in the “+” direction, the blue color will become thicker. When the cursor is movedin the “-” direction, the blue color will be thinner. Click the [Reset] button to reset the color to the default.• Default: 128100 Operating Instructions11 Configure the settings relating to images and audio [Image/Audio]
