Click the “Set” button.4. Configure the settings of Camera 2 (IP address: 192.168.0.12), which receives notification commands fromthe other cameras.Display the “Alarm” screen from the “Alarm” page. (®page 129)From “Alarm”, set “Command alarm” to “On” and click the “Set” button.Set the “Command alarm” of “Camera action on alarm” to “Preset per sender”, and click “Preset persender >>”.On the “Preset per sender” page (®page 132), check the “Auto track cooperation” checkbox of“Sender's address 1” (any destination address can be used) and enter 192.168.0.11 (Camera 1) forthe sender’s address. Then select the preset position set at step 2, click the “Set” button, and thenclose the page.Click the “Set” button.5. Auto track cooperation can be used by starting the auto tracking for Camera 1.11.6.8 Configure the settings relating to direction (“Direction”setup menu) (WV-SW396/WV-SC386)Click the [Setup>>] button of “Direction” on the [Image/Position] tab of the “Image/Audio” page (®page 94).Here the information related to the direction setting is set. The pan/tilt position moves to the position set whendisplaying this page.Direction setting[North point setting]If “Direction display” is selected for “Camera position display”, one of the eight directions will be indicatedinstead of the preset position title when the camera is not at the preset position.Determine the direction setting by adjusting the displayed panning position to the north (N) indication.[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] buttonRefer to page 10 for descriptions of how to operate these buttons/pad.Operating Instructions 12111 Configure the settings relating to images and audio [Image/Audio]
